Kyocera FS 2020D Advanced Operation Manual page 137

>Font Select
Internal
>>Courier
Regular
>>Courier
?Regular
>Font Select
Internal
>>Size
012.00 point(s)
>>Size
012.00 point(s)
7-40
5
Press or
font numbers of the internal fonts, refer to Print Fonts List on page 7-
15.
6
When the desired font is displayed, press [OK].
7
Press [MENU]. The display returns to Ready.
Selecting Regular or Dark Courier/Letter Gothic
Courier or Letter Gothic font thickness can be selected as Regular or
Dark. In the procedure below, it is assumed that Courier is selected. The
procedure is the same for Letter Gothic.
1
while Print Settings > is displayed.
Press
2
Press or
>
3
Make sure that Internal is displayed and press
4
Press or
selecting the thickness of the Letter Gothic font, choose >>Letter
Gothic here instead.
5
Press [OK]. A blinking question mark (?) appears.
6
Select Regular or Dark using
7
Press [OK].
8
Press [MENU]. The display returns to Ready.
Changing the Default Font Size
You can change the size of the default font. If you selected a proportional
font, the character size can also be changed.
1
while Print Settings > is displayed.
Press
2
Press or
>
3
Make sure that Internal is displayed and press
4
Press or
5
Press [OK]. A blinking question mark (?) appears.
6
Press or
cursor. The font size can be set between 4 and 999.75 points, in
0.25-point increments. Use
7
When the desired size is displayed, press [OK].
8
Press [MENU]. The display returns to Ready.
repeatedly until the desired font number appears. For
repeatedly until >Font Select > appears.
repeatedly until >>Courier appears. If you are
or
repeatedly until >Font Select > appears.
repeatedly until >>Size appears.
to increase or decrease the value at the blinking
or to move the cursor right and left.
.
.
.
Using the Operation Panel