Kyocera FS 2020D Advanced Operation Manual page 53

>TCP/IP (IPv6) >
On
>>RA(Stateless)
Off
>>DHCPv6
Off
>>RA(Stateless)
?Off
>>DHCPv6
?Off
Security
4-6
TCP/IP (IPv6)
This section describes how to enable the TCP/IP (IPv6) protocol.
1
If TCP/IP (IPv6) is set to Off, use
press [OK].
2
Press . Each time you press
3
Display the item you want to set and press [OK]. A blinking question
mark (?) appears while you are setting RA(Stateless) and
DHCPv6.
4
Press or
RA(Stateless) and DHCPv6.
Note
Check with your network administrator for the network
address settings.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
NetWare, AppleTalk, IPP, SSL Server, IPSec and
Security Level settings
1
Press [MENU].
2
Press or
>
or , the selection changes.
to select On or Off as the setting for
repeatedly until Security > appears.
to selecto On and
or
Connecting and Printing