Rear Unit; Envelope Feeder - Kyocera FS 2020D Advanced Operation Manual

6-18

Rear Unit

1
If paper is not completely ejected into the output tray, open the rear
unit.
2
Open the fuser cover and remove the jammed paper by pulling it out.
Note
If you cannot find a paper jam, try checking inside the
rear of the printer.
CAUTION
touch it with your hands as it may result in burn injury.
Remove jammed paper carefully.
3
Close the rear unit. The printer warms up and resumes printing out.

Envelope Feeder

Paper is jammed at the optional envelope feeder. Remove the jammed
paper using the same procedure as for a jam at the MP Tray. Then, open
and close the paper transfer unit. For details, refer to the User's Manual
for the envelope feeder.
Bulk Paper Feeder
Paper is jammed at the optional bulk paper feeder. Detach the bulk
paper feeder from the printer by sliding with the rail away from the
printer, holding the bulk paper feeder by both hands. If paper is partially
fed out from the feeder's output slot, pull the paper out by hand.
The fuser unit inside the printer is hot. Do not
Troubleshooting