Subnet Mask - Kyocera FS 2020D Advanced Operation Manual

>TCP/IP
On
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
>>Bonjour
Off
>>Subnet Mask
000.000.000.000
Connecting and Printing
TCP/IP
This section describes how to enable the TCP/IP protocol.
1
If TCP/IP is set to Off, use
>
2
Press . Each time you press
3
Display the item you want to set and press [OK]. A blinking question
mark (?) appears while you are setting DHCP and Bonjour. A
blinking cursor (_) appears while you are setting IP Address,
Subnet Mask and Gateway.
4
Press or
Bonjour.
For the IP Address, Subnet Mask and Gateway settings, press
or to move the blinking cursor to the number you want to
change (000 to 255). Use
Note
Check with your network administrator for the network
address settings.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
to select On and press [OK].
or
or , the selection changes.
to select On or Off as the setting for DHCP and
and to move the cursor right and left.
4-5