Kyocera FS 2020D Advanced Operation Manual page 120

>Private/Stored
?Harold
>Arlen
?Agenda
>Agenda
ID
>Agenda
Copies
Using the Operation Panel
Private/Stored (Printing a Private Print/Stored Job)
In private printing, you can specify that a job is not printed until you
release the job from the operation panel. When sending the job from the
application software, specify a 4-digit access code in the printer driver.
The job is released for printing by entering the access code on the
operation panel ensuring confidentiality of the print job.
In the stored job mode, access codes are not mandatory, but can be set
on the printer driver if printing with PIN security is required. Then, the
access code must be entered on the operation panel to print a stored
job. Print data will be stored in the hard disk/RAM disk after printing.
Refer to KX Printer Driver User Guide for the driver settings.
Releasing a Private/Stored Job
1
while Job Box > is displayed.
Press
2
Press
name entered in the printer driver (Harold, in this example) also
appears.
3
Press [OK]. A blinking question mark (?) appears before the user
name.
4
Press
example).
5
Press [OK]. The user name and the job name (Agenda, in this
example) entered in the printer driver appear with a blinking question
mark (?).
6
Press
7
Press [OK]. The ID input line appears. Enter the four-digit access
code entered in the printer driver and press [OK].
0000
To enter the ID, press
changed and then enter the correct number by pressing
8
You can set the number of copies to be printed. To increase the copy
count, press
001
9
Press [OK] to finalize the copy count. The printer prints the specified
number of copies for the job.
repeatedly until >Private/Stored appears. The
or
or to display the desired user name (Arlen, in this
or to display the desired job title.
or to move the cursor to the number to be
; to decrease the copy count, press
or .
.
7-23