Kyocera FS 2020D Advanced Operation Manual page 136

>Emulation
? PCL 6
>Emulation
? KPDL (AUTO)
>>Error Report
? On
>Font Select
Internal
>> I000
>>?I000
Using the Operation Panel
Error Report (Printing KPDL errors)
The printer can print error descriptions when printing error occurs during
KPDL emulation. The default is On — the printer prints KPDL errors.
1
while Print Settings > is displayed.
Press
2
Press or
3
Press [OK]. A blinking question mark (?) appears.
4
Select KPDL or KPDL (AUTO) using
>
5
. >>Error Report appears.
Press
6
Press [OK]. A blinking question mark (?) appears.
7
Select On or Off using
8
Press [MENU]. The display returns to Ready.
Font Select (Selecting the default font)
You can select the default font for the current interface. The default font
can be one of the internal fonts or a font that is downloaded to the printer
memory or stored on CompactFlash card, or hard disk.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as to print a font list.
1
while Print Settings > is displayed.
Press
2
Press or
>
3
To select an internal font, make sure that Internal is displayed
and press . The display changes. If Internal is not displayed, press
[OK], then press
To select an optional font, press [OK] while >Font Select > is
displayed. Press
press [OK]. Press
You can perform this operation only when optional fonts are installed
in the printer.
The letter before the number indicates the location of the font, as
shown below.
I: Internal font
S: Soft (downloaded) font
M: Fonts in optional CompactFlash card
H: Fonts in RAM disk or optional hard disk
4
Press [OK]. A blinking question mark (?) appears.
repeatedly until >Emulation > appears.
. Press [OK].
or
repeatedly until >Font Select > appears.
or until it appears.
or repeatedly until Option appears and then
next to display the font selection shown above.
. Press [OK].
or
7-39