Kyocera FS 2020D Advanced Operation Manual page 158

>>Sleep Timer
Using the Operation Panel
Sleep Timer (Sleep timer timeout time)
You can adjust the length of time the printer waits before entering Auto
Sleep in the absence of data.
The printer reverts to normal operation mode when the printer receives a
print job, the operation panel is operated, or one of the exterior covers is
opened. The default time is 30 minutes.
Note
reverts to normal operation mode.
1
Press
2
Press
3
To change the timeout time, press [OK]. A blinking cursor (_)
appears.
030 min.
4
Press
cursor and set the desired time. The timer can be set between 1 and
240 minutes. Use
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Calibration is automatically executed before the printer
while >Timer > is displayed.
repeatedly until >>Sleep Timer appears.
or
or to increase or decrease the value at the blinking
and to move the cursor right and left.
7-61