Kick Start Assembly - Husqvarna TC 250 2010 Workshop Manual

ENGINE REASSEMBLY

Kick start assembly

Refit the starter ratchet release plate (1) (use a 4 mm wrench, 8 Nm, 0.8 Kgm,
5.8 ft/lb, Loctite 243).
Fit the complete shaft assembly (2) to its seat (B) in the crankcase, making sure
the ratchet is correctly positioned on the shaft (marks lined up) and insert the
spring end (3) into the hole (D).
Fit transmission gear (4), washer (5) and snap ring (6).
Part. N. 8000 H1489 (10-2009) H.33