Javad ALPHA Operator's Manual page 57

Parameter
Baud rate
RTS/CTS
Figure 3-17. Base and Rover Configuration for RTK measurings – Ports
10. Click the Advanced tab and then the Multipath tab. Set the following parameters and click
Apply (Figure 3-18 on page 58).
• Code multipath reduction – enable
www.javad.com
Base Receiver
Select a baud rate to use for transmitting differential messages from
the receiver board to the modem module.
The baud rate must match the modem's serial port speed.
Select to enable handshaking.
Configuration
Configuring the Receiver
Configuring the GSM module for Internet access
Rover Receiver
57