Turning On/Off The Receiver; Connecting The Receiver And A Computer; Establishing A Wireless Connection - Javad ALPHA Operator's Manual

2.4.1. Turning On/Off the Receiver

To turn ON the receiver, press and hold the power button until the LEDs briefly flash. To turn OFF
the receiver, press and hold the power key for more than one and less than four seconds (until both
the STAT and the REC LEDs are off).
This delay (about 1 second) will prevent the receiver from being turned off by mistake.

2.5. Connecting the Receiver and a Computer

JAVAD GNSS TriVU software provides an interface for various configuration, monitoring, and
management functions for the receiver.
To configure, manage files, or maintain the receiver, connect the receiver and a computer using
one of the following methods and start TriVU:
• a Bluetooth®-enabled external device (computer/controller)
• an RS232 cable and a computer/controller
• a USB cable and a computer/controller with the JAVAD GNSS USB driver installed
Once you have established a connection between the receiver and the computer/controller, you
will be able to configure the receiver and its components, send commands to the receiver,
download files from the receiver's memory; as well as, upload new firmware, upload an OAF, and
upload configuration files to a receiver, using TriVU.

2.5.1. Establishing a Wireless Connection

The ALPHA receiver contains Bluetooth
synchronization between the receiver and any other external device that supports Bluetooth
wireless technology; for example, an IPAQ, or a computer with USB-to-Bluetooth
®
PCMCA-to-Bluetooth
Note:
Changing the receiver's Port E default settings will affect the Bluetooth® link. The default
settings for Port E are 115200 bps, 8 data bits, 1 stop bit, no parity, and no handshaking.
The ALPHA receiver and external device connection procedure varies slightly depending on the
type of external device used. In general, the connection procedure is as follows:
Note:
Refer to your Bluetooth
information.
www.javad.com
®
wireless technology that allows file transfer and
adapter installed.
®
-enabled external device documentation for more detailed connection
Pre-measuring Preparation
Connecting the Receiver and a Computer
Turning On/Off the Receiver
®
adapter or
®
33