User Manual of Network Speed Dome
2. Set the RS-485 parameters and click
The Baud Rate, PTZ Protocol and PTZ Address parameters of the speed
dome should be exactly the same as those of the control device.
10.9 Configuring IR Light
This function is only applicable to the IR speed domes.
Steps:
1. Enter IR Light Setting interface:
Configuration> Advanced Configuration> System > Service
2. Check the checkbox to enable the IR light when the illumination is not enough for
the video monitoring.
3.
Click the
10.10 Configuring Remote Connection
Steps:
1. Enter the interface of configuring the remote connection:
Configuration> Advanced Configuration> System > Service
2. Input a number in text field as the upper limit of the remote connection number.
E.g. when you specify the remote connection number as 10, then the 11th
remote connection cannot be established.
3. Click the
© Hikvision
Figure 10-15 Setting IR Light
button to activate the settings.
button to activate the settings.
to save the settings.
114