HIKVISION Network Speed Dome User Manual page 28

User Manual of Network Speed Dome
 Calling a Preset:
In the PTZ control panel, select a defined preset from the list and click
preset.
For convenient preset selection, refer to the following steps to navigate to the preset
you want.
Steps:
1. Select any preset from the list.
2. Click the preset number you need on the keyboard.
The following presets are predefined with special commands. You can only call
them but not configure them. For instance, preset 99 is the "Start auto scan". If
you call the preset 99, the speed dome starts auto scan function.
Special
Preset
33 Auto flip
34 Back to initial position
35 Call patrol 1
36 Call patrol 2
37 Call patrol 3
38 Call patrol 4
39 IR cut filter in
40 IR cut filter out
41 Call pattern 1
42 Call pattern 2
43 Call pattern 3
44 Call pattern 4
45 Automatically Create Patrol
© Hikvision
Figure 4-6 Calling a Preset
Table 4-3 Special Presets
Function Special Function
Preset
93 Set limit stops manually
94 Remote reboot
95 Call OSD menu
96 Stop a scan
97 Start random scan
98 Start frame scan
99 Start auto scan
100 Start tilt scan
101 Start panorama scan
102 Call patrol 5
103 Call patrol 6
104 Call patrol 7
105 Call patrol 8
27
to call the