Configuring Recording Schedule - HIKVISION Network Speed Dome User Manual

96
User Manual of Network Speed Dome

7.3 Configuring Recording Schedule

Before you start:
Please make sure a local storage card is inserted in the speed dome or the network
storage is added to the speed dome, and the
Purpose:
There are two kinds of recording for the speed domes: manual recording and
scheduled recording. For the manual recording, refer to Section 4.4 Recording and
Capturing Pictures Manually. In this section, you can follow the instructions to
configure the scheduled recording. By default, the record files of scheduled recording
are stored in the SD card (if supported) or in the network disk.
Steps:
1. Enter the Record Schedule Settings interface:
Configuration > Advanced Configuration> Storage > Record Schedule
Figure 7-7 Recording Schedule Interface
2. Check the checkbox of Enable Record Schedule to enable scheduled recording.
3. Set the record parameters of the speed dome.
Figure 7-8 Record Parameters
 Pre-record: The time you set to start recording before the scheduled time or
© Hikvision