HIKVISION Network Speed Dome User Manual page 48

User Manual of Network Speed Dome
2. Configure the NIC settings, including the IPv4(IPv6) Address, IPv4(IPv6) Subnet
Mask and IPv4(IPv6) Default Gateway.
3. Click to save the above settings
 If the DHCP server is available, you can check
an IP address and other network settings from that server.
 If the IP address is set manually, you can click
IP address is already used to prevent the IP address confliction.
 The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 9676. The
default value is 1500.
 The Multicast sends a stream to the multicast group address and allows multiple
clients to acquire the stream at the same time by requesting a copy from the
multicast group address.
Before utilizing this function, you have to enable the Multicast function of your
router and configure the gateway of the network speed dome.
 If the DNS server settings are required for some applications (e.g., sending
email), you should properly configure the Preferred DNS Server and Alternate
DNS server.
 Check the checkbox of Enable Multicast Discovery, and then the speed dome
can be detected by client software in the LAN.
© Hikvision
Figure 6-7 TCP/IP Settings
.
47
to automatically obtain
to check whether the