Chapter 2 Network Connection; Setting The Network Speed Dome Over The Lan; Wiring Over The Lan - HIKVISION Network Speed Dome User Manual

User Manual of Network Speed Dome

Chapter 2 Network Connection

Before you start:
 If you want to set the network speed dome via a LAN (Local Area Network),
please refer to Section 2.1 Setting the Network Speed Dome over the LAN.
 If you want to set the network speed dome via a WAN (Wide Area Network),
please refer to Section 2.2 Setting the Network Speed Dome over the WAN.

2.1 Setting the Network Speed Dome over the LAN

Purpose:
To view and configure the speed dome via a LAN, you need to connect the network
speed dome in the same subnet with your computer, and install the SADP or client
software to search and change the IP of the network speed dome.
For the detailed introduction of SADP, please refer to Appendix 1.

2.1.1 Wiring over the LAN

The following figures show the two ways of cable connection of a network speed
dome and a computer:
Purpose:
 To test the network speed dome, you can directly connect the network speed
dome to the computer with a network cable as shown in Figure 2-1.
 Refer to the Figure 2-2 to set the network speed dome over the LAN via a switch
or a router.
© Hikvision
Network Cable
Figure 2-1 Connecting Directly
11