Chapter 5 Ptz Configuration; Configuring Initial Position; Configuring Basic Ptz Parameters - HIKVISION Network Speed Dome User Manual

User Manual of Network Speed Dome

Chapter 5 PTZ Configuration

5.1 Configuring Initial Position

Purpose:
The initial position is the origin of PTZ coordinates. It can be the factory default initial
position. You can also customize the initial position according to your own demand.
Customize an Initial Position:

Steps:
1. Enter the Initial Position Configuration interface:
Configuration > Advanced Configuration > PTZ > Initial Position
2. Click the PTZ control buttons to find a position as the initial position of the dome;
you can also call a defined preset and set it as the initial position of the dome.
3. Click Set to save the position.
Call/delete an Initial Position:

You can click
initial position and restore the factory default initial position.

5.2 Configuring Basic PTZ Parameters

Purpose:
© Hikvision
Figure 5-1 PTZ Configuration
to call the initial position. You can click
32
to delete the