Configuring Output Standard; Configuring Ir Parameters - HIKVISION DS-2AE4215T-D User Manual

If no privacy mask has been configured, you cannot set the status to ON.
5. Delete the privacy mask.
You can enter the CLEAR MASK menu to delete the all the configured privacy mask.

3.3.3 Configuring Output Standard

Purpose:
The video output standard, including resolution and frame rate, can be changed according to the
actual requirement.
Steps:
1. Move the cursor to enter the Video Settings submenu:
MAIN MENUS > SYS SETTINGS > VIDEO SETTING
2. Move the cursor to VIDEO STD and click IRIS+ to enter the editing mode.
3. Click the up and down direction buttons to select a desired video standard.
4. Click IRIS+ again to confirm and exit the editing mode.

3.3.4 Configuring IR Parameters

The IR parameter settings are supported by IR speed domes only.
Purpose:
You can configure the IR parameters including the IR sensitivity, N/M LED current, far LED current,
reference zoom, and LED control, switch delay, smart IR, etc.
Enter the LED parameter submenu:
MAIN MENUS > SYS SETTINGS >IR PARAMETER
 Set the sensitivity of the IR LED.
You can set the SENSITIVITY to HIGH, MEDIUM, or LOW.
HD-TVI Speed Dome User Manual
IR PARAMETER
IR SENSITIVITY MEDIUM
N/M LED CURRENT
FAR LED CURRENT
REFERENCE ZOOM
LED CONTROL
SWITCH DELAY(S)
SMART IR
BACK EXIT
Figure 3-10 IR Settings
8
8
2
ICR
2
0
20