Table of Contents
Advertisement
User Manual of HD-TVI Speed Dome
actual requirement.
Steps:
1. Move the cursor to enter the Vide Settings submenu:
MAIN MENUS > DOME SETTINGS > VIDEO SETTINGS
2. Move the cursor to VIDEO STD and click IRIS+ to enter the editing mode.
3. Click the up and down direction buttons to select a desired video standard.
4. Click IRIS+ again to confirm and exit the editing mode.
3.3.6 Configuring IR Parameters
The IR parameter settings are supported by IR speed domes only.
Purpose:
You can configure the IR parameters including the IR sensitivity, n/m LED current, reference height,
reference zoom, and LED control, fan control, switch delay, heat control, and IR correction, etc.
Enter the LED parameter submenu:
MAIN MENU > DOME SETTINGS >IR SETTINGS
Set the sensitivity of the IR LED.
You can set the SENSITIVITY to HIGH, MEDIUM, or LOW.
Set the electricity level of the IR LED.
The N/M LED CURRENT and the FAR LED CURRENT refer to the electricity level of the
near/middle IR LED and far IR LED correspondingly. You can set the near/far LED current and the
far LED current to 1~10.
Set the parameters of IR LED switching.
ZOOM LIMIT
When the actual zooming rate is larger than the zoom limit, it will switch to the far-distance
IR LED; when it's smaller than the zoom limit, it will switch to the near/medium-distance IR
LED.
IR CONTROL
LED control can be set to ALL ON (enable all the IR LED), FAR ON (enable far-distance IR LED),
© Hikvision
Lo-Call 1890 866 900
IR SETTINGS
SENSITIVITY
MEDIUM
N/M LED CURRENT
FAR LED CURRENT
ZOOM LIMIT
IR CONTROL
AUTO
SWITCH DELAY(S)
BACK
EXIT
Figure 3-10 IR Settings
www.cctvireland.ie
8
8
4
2
hikvision@cctvireland.ie
20
Advertisement
Table of Contents
