HIKVISION Network Speed Dome User Manual page 34

User Manual of Network Speed Dome
You can configure the basic PTZ parameters, including proportional pan, preset
freezing, preset speed, etc.
1. Enter the Basic PTZ Parameter Configuration interface:
Configuration > Advanced Configuration > PTZ > Basic
2. Configure the following settings:
Basic Parameters: Enable/disable proportional pan and preset freezing, set the

preset speed, keyboard control speed, and auto scan speed.
 Proportional Pan: If you enable this function, the pan/tilt speeds change
according to the amount of zoom. When there is a large amount of zoom, the
pan/tilt speed will be slower for keeping the image from moving too fast on
the live view image.
 Preset Freezing: This function enables the live view to switch directly from
one scene defined by a preset to another, without showing the middle areas
between these two, to ensure the surveillance efficiency. It can also reduce
the use of bandwidth in a digital network system.
Preset freezing function is invalid when you calling a pattern.
 Preset Speed: You can set the speed of a defined preset from 1 to 8.
 Keyboard Control Speed: Define the speed of PTZ control by a keyboard as
Low, Normal or High.
 Auto Scan Speed: The dome provides 5 scan modes: auto scan, tilt scan,
frame scan, random scan and panorama scan. The scan speed can be set from
level 1 to 40.
 Zooming Speed: The zoom speed is adjustable from level 1 to 3.
PTZ OSD: Set the on-screen display duration of the PTZ status.

 Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds,
10 seconds, Always Close or Always Open.
© Hikvision
Figure 5-2 Basic PTZ Configuration Interface
33