Table of Contents
Advertisement
Before You Start
The picture to overlay has to be in BMP format with 24-bit, and the maximum picture size is 128 ×
128 pixel.
Steps
1. Go to Configuration → Image → Picture Overlay .
2. Check Enable.
3. Click Upload to select a picture and open it.
The picture with a red rectangle will appear in live view after successfully uploading.
4. Drag the red rectangle to adjust the picture position.
5. Click Save.
4.9 Set IR Light
The camera has multiple sets of IR lights that can be enabled or disabled separately.
Steps
1. Go to Configuration → Image → IR Light .
2. Check to enable certain sets of IR lights.
For the camera supporting three sets of IR lights, the three sets of IR lights are named as No. 1
●
to No. 3 clockwise starting from the dial mark 0° to 240° on camera body.
For the camera supporting four sets of IR lights, the four sets of IR lights are named as No. 1 to
●
No. 4 clockwise starting from the dial mark 0° to 270° on camera body.
Note
Without the one-to-one control, the enabled IR lights work as a group. Signal from any camera
channel can control their on/off status.
3. Optional: Enable One-to-One Control. Set linkage between IR light and channel.
- Function enabled: You need to set linkage between IR light and channel. For example, if the
No. 1 IR light is linked to the channel 1, and channel 1 is set in night mode, the No. 1 IR light
will be enabled.
- Function disabled: If one of the channels is set in night mode, all sets of IR lights configured
with IR enabled will be switched to on status at the same time.
4. Click Save.
Network Camera User Manual
26
Advertisement
Table of Contents
