HIKVISION Network Speed Dome User Manual page 91

User Manual of Network Speed Dome
Region entrance detection function detects people, vehicle or other objects which
enter a pre-defined virtual region from the outside place, and some certain actions
can be taken when the alarm is triggered.
Steps:
1. Enter the Region Entrance Detection settings interface:
Configuration> Advanced Configuration> Smart Event> Region Entrance
Detection
2. Check the checkbox of Enable Region Entrance Detection to enable the
function.
Figure 6-60 Configuring Region Entrance Detection
3. Select the region from the dropdown list for detection settings.
4. Click the
5. Click on the live video to specify the four vertexes of the detection region, and
right click to complete drawing.
Repeat the step to configure other regions. Up to 4 regions can be set. You can
click the
6. Click the
Section 6.6.1 Configuring Motion Detection.
7. Select the linkage methods for region entrance detection, including Notify
Surveillance Center, Send Email, Upload to FTP, Trigger Channel and Trigger
Alarm Output. Please refer to Step 3 in Section 6.6.1 Configuring Motion
Detection.
8. Click
© Hikvision
button to start the region drawing.
button to clear all pre-defined regions.
button to set the arming schedule. Refer to Step 2 in
button to save the settings.
90