Operation And Function - Icom IC-F9511T User Manual

▒ NOTE : Operation of the IC-F9521/F9523/S/T is also based on this instruction.
➊ AF VOLUME CONTROL KNOB
Rotate the knob to adjust the audio output level.
• Minimum audio level is pre-programmed.
➋FUNCTION DISPLAY
Displays a variety of information, such as an operating
channel number/name, DTMF numbers and audible
condition, etc.
➌UP/DOWN or DIAL KEYS
• 10-key model: UP/DOWN Keys
Push to select an operating channel, etc.
• Simple model: DIAL
Rotate to select an operating channel, etc.
*The desired function can be assigned by your
dealer.
➍10-KEYPAD (10-key model only)
The keypad allows you to enter digits to:
• Select memory channels, tone channels and DTMF S l t h
codes (when in the DTMF code channel selection
mode)
• Start up with a password
• Input the Individual ID code for digital operation.
(Depending on the pre-set value)
➎BUSY INDICATOR
Lights green while receiving a signal or when the Lights green while receiving a signal, or when the
squelch is open.
➏POWER SWITCH [POWER]
Push to turn the power ON and OFF.
• The following functions are available at power ON as
options:
➣ Automatic scan start
➣ Password prompt ➣ Password prompt
➣ Set mode
➐TRANSMIT INDICATOR
Lights red while transmitting.
* P25 operation only
26
4-1

Operation and Function

4-1-1 Operation and Function
IC-F9511S, IC-F9511T
l t h l d DTMF
➑DEALER-PROGRAMMABLE KEYS
Desired functions can be programmed independently
by your dealer. In this instruction manual, these keys
are from the left, called [P0]/[P1]/[P2]/[P3]/[P4]. are from the left called [P0]/[P1]/[P2]/[P3]/[P4]
➒MICROPHONE CONNECTOR
Connect the supplied or optional microphone.
• When you connect a microphone, be sure to fit the
connector cover of the microphone into the
connector to maintain the front panel's dust
protection and splash resistance*.
*Only when the optional RMK-2 is attached. y p
RMK-2
Connector cover
▒ NEVER connect non-specified microphones.
▒ The pin assignments may be different and the
▒ transceiver may be damaged.
MICROPHONE
The supplied microphone has a PTT switch and a
hanger hook.
• The following functions are available when the
microphone is on or off hook (depending on the
setting):
➣ Automatic scan starts when it is on hook.
➣ Scan is cancelled when it is off hook.
➣ Scan is paused when it is off hook.
➣ Automatic priority channel selection is available
when it is off hook.
➣ Sets to 'Inaudible' condition (mute condition)
when it is on hook.
➣ Sets to 'Audible' condition (unmute condition)
when it is off hook.
10 keypad
model
Up/Down Key
Simple model Si l d l
Dial Key