Icom IC-F9511T User Manual page 51

5Push [Digital Button] (or [Digital Status]) again to
enter the Individual ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
6Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] (or [Digital Status])
for 1 sec to cancel and return to normal operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key models only.
7Push [PTT] to transmit the Status Message to
the target station.
• The Transmit indicator lights red.
• "PLEASE WAIT" is displayed.
8Release [PTT].
• "ACK RECEIVED" is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation. then the transceiver returns to normal operation
• "NO ACKNOWLDG" is displayed when an
acknowledgement is not received and the
transceiver returns to normal operation.
Receiving
1When a Status Message is received;
• The Busy indicator lights green.
• The ringer sounds The ringer sounds.
(Depending on the pre-set value.)
• The calling station ID name (or code) and the
Status Message blinks.
The received message
The calling station ID name
2An acknowledgement is automatically
transmitted.
• The Transmit indicator lights red.
3Push any key (except for [ ]) to stop the display
from blinking and return to normal operation.
APCO P25 Mode Operation
■ Short Message
Transmitting
The transceiver can send one of up to 10 different
pre-programmed Short Messages.
[Digital Button] or [Digital Message] key
assignment is necessary to transmit the Short
Message.
✔ For Trunking mode operation:
The Short Message can be sent only to a dispatcher
in the Trunking mode.
1Push [Digital Button] to enter the digital call
type selection mode.
▒ ✔ Quick access
▒ Push [Digital Message] to directly enter the ▒
▒ Short Message selection mode. In this case,
▒ skip steps 2 and 3. Go to step 4.
2Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select "SHORT MSG."
3Push [Digital Button] again to enter the Short
Message selection mode.
*A pre-programmed Short Message is displayed.
4Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired Short
Message.
▒ While in the Trunking mode, the following steps
▒ 5and 6 are not necessary. Go to step 7. ▒ 5and 6 are not necessary Go to step 7
5Push [Digital Button] (or [Digital Message]) again
to enter the Individual ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed,
the ID code is displayed.
g
[ g g ] y
51