ETV mille
6.17 BEAM HEIGHT SETTING
The headlight is made up of two light units:
- Rh headlight unit (1);
- Lh headlight unit (2).
Each light unit has independent adjusters for beam
setting.
Adjust both light units and then ensure:
- that the beam is uniform;
- that there are no dark spots.
NOTE
Beam inspection procedures may vary from
country to country. Observe the law in force in the
country of the user.
To set beam height:
NOTE
The instructions below apply to both light units.
!
Remove
the
front
(REMOVING THE FRONT FAIRING).
!
Sit astride the motorcycle.
!
Right-hand headlight unit (1): Working on the rear
right-hand side of the front fairing, rotate the adjuster
wheel (3):
ROTATE CLOCKWISE to lower the beam;
ROTATE ANTI-CLOCKWISE to raise the beam.
!
Left-hand headlight unit (2):
hand unit adjustment, however, rotate the
adjuster wheel (4).
When finished:
CAUTION
Check for proper beam height setting.
Release 00/2004 - 04
fairing
panel,
see 7.1.18
Proceed as for right-
ELECTRICAL SYSTEM
1
10 m
4
2
3
6
- 53 -
00