Tail Light Bulb Replacement - APRILIA ETV mille Workshop Manual

ETV mille

6.15.4 TAIL LIGHT BULB REPLACEMENT

The tail light accommodates:
- two bulbs for parking / brake lights (1).
To replace a bulb:
Before changing a bulb, check the BRAKE light switches
for proper operation, see 6.13.2 (SWITCHES).
NOTE
The procedure described below applies to both
bulbs.
CAUTION
Allow for the exhaust silencer to cool down
completely.
!
Put the motorcycle on the stand.
!
Release and remove the two screws (2).
!
Remove the protective shield (3).
WARNING
On refitting, locate the protective shield correctly
into its seat. Tighten the screws (2) gradually. Do not
overtighten or the protective shield will damage.
!
Push down on the bulb (1) lightly and twist anti-
clockwise.
!
Extract the bulb (1) from the bulb holder.
WARNING
When fitting the bulb, ensure that the two locating
pegs locate properly into the slots in the bulb holder.
!
Install a new bulb of equal rating.
6.15.5 TAIL LIGHT BULB REPLACEMENT
!
Place the motorcycle on the stand.
CAUTION
Allow for the engine to cool down completely.
WARNING
Do not pull on the wiring to extract the bulb holder.
!
Grasp the bulb holder (2) from behind the number plate
bracket. Pull the bulb holder to extract.
!
Extract the bulb (1) and install a new bulb of equal
rating.
Release 00/2004 - 04
ELECTRICAL SYSTEM
1
2
2
3
1
6
- 51 -
00