Adjusting The Headlight Beam; Changing The Fuses - APRILIA Quasar 50 Manual

ELECTRIC SYSTEM
1
1
2
5
- 10 -
00
5.5.5

ADJUSTING THE HEADLIGHT BEAM

To rapidly check the correct direction of the beam, place the vehicle on flat
ground, 10 m away from a wall.
Turn on the low beam, sit on the vehicle and make sure that the beam
projected on the wall is slightly under the horizontal line of the headlight (about
9/10th of the total height).
To adjust the headlight beam:
Use a screwdriver to adjust the screw (1).
By SCREWING IT IN (clockwise), you set the beam downwards.
By UNSCREWING IT (anti-clockwise), you set the beam upwards.
5.5.6

CHANGING THE FUSES

Read carefully 1.3 (GENERAL SAFETY RULES).
Do not repair faulty fuses.
Never use fuses different from the recommended ones.
The use of unsuitable fuses may cause damages to the electric system
or, in case of short circuit, even a fire.
IMPORTANT
If a fuse blows frequently, there probably is a short circuit or an
overload in the electric system.
If an electric component does not work or works irregularly, or if the vehicle
fails to start, it is necessary to check the fuse.
For the check, proceed as follows:
Remove the seat, see 6.1.1 (REMOVING THE SEAT).
Disconnect the battery cables, see 6.1.7 (REMOVING THE BATTERY).
Extract the fuse (2).
IMPORTANT
When you find a blown fuse, determine and rectify the cause
before fitting a new fuse.
Replace the damaged fuse with a new one having the same amperage.
QUASAR 50-100
Release 00/2003 - 06