Refitting The Wheel - APRILIA ETV mille Workshop Manual

ETV mille

7.2.5 REFITTING THE WHEEL

Read 0.5.1 (GENERAL
INFORMATION) carefully.
WARNING
Use great care when refitting the wheel to avoid damaging
the brake lines, brake discs and brake pads. The arrow
mark on the wheel side points in the direction of rotation.
Make sure to refit the wheel in the correct direction: the
arrow mark must be on the motorcycle left-hand side.
!
Place the motorcycle on the front wheel stand
see 1.9.1 (PLACING THE MOTORCYCLE ON THE
FRONT WHEEL STAND)
!
Smear a light coat of grease (part no. 8116053) over
the total length of the wheel spindle (1).
!
Place the wheel between the fork legs.
WARNING
Do not attempt to align the holes by putting your fingers
into the holes. This could result in severe personal injury.
!
Move the wheel until the wheel hub bore aligns with the
holes in the forks.
!
Slide the wheel spindle (1) fully home.
!
Fit the washer and screw the nut (2) hand-tight.
!
Tighten the two wheel spindle clamp bolts (3) to
prevent wheel spindle (1) rotation.
Torque wrench setting for wheel spindle clamp
bolts (3): 10 Nm (1.0 kgm).
!
Tighten the nut (2) to the specified torque.
Torque wrench setting for wheel hub nut (2):
80 Nm (8.0 kgm).
!
Tighten the two wheel spindle clamp bolts (4) to the
specified torque.
Torque wrench setting for wheel spindle clamp
bolts (4): 10 Nm (1.0 kgm).
WARNING
Use great care or you might damage the brake pads.
!"
Fit the brake caliper (5) to the brake disc with the
mounting holes aligned with the holes in the caliper carrier.
WARNING
Replace both caliper (5) mounting bolts (6) with new
bolts of the same type fitted originally. Lubricate with
oil (part no. 8116050).
!"
Start the two caliper mounting bolts (6) in their holes
and tighten to the specified torque.
Torque wrench setting for caliper mounting
bolts (6): 50 Nm (5.0 kgm).
!
Slacken the two wheel spindle clamp bolts (3).
Release 00/2004 - 04
PRECAUTIONS AND
,
4
2
6
CHASSIS
1
3
4
5
7 - 57 -
00