Setting The Clock (Hours And Minutes); Instrument And Indicator Chart - APRILIA ETV mille Workshop Manual

PERIODIC MAINTENANCE AND ADJUSTMENTS
2.3.6 SETTING THE
MINUTES)
NOTE
The clock can only be set when the motorcycle
is at standstill.
&
Hold down the MODE button (1) for over three
seconds. The hour segments (2) will start to flash.
NOTE
Press and release the SET button (3) alternately
to change hours in one-unit increments. Hold down the
SET button (3) to cycle through hours quickly.
&
Press the SET button (3) and set hours.
&
Press and release the MODE button (1) to confirm. The
minute segments (4) will start to flash.
&
Press the SET button (3) and set minutes.
&
Press and release the MODE button (1) to confirm.
NOTE
The clock will reset automatically whenever the
battery is removed from the vehicle.

2.3.7 INSTRUMENT AND INDICATOR CHART

Description
Direction indicator LED light
High beam LED light
Rev. meter (rpm)
Fuel reserve LED light
Side stand LED light
Oil pressure LED light
Neutral LED N light
Diagnostics LED light
Speedometer (kph)
2 - 10 -
00
CLOCK (HOURS AND
Flashes when a direction indicator is operated.
Comes on when headlamp high beam is turned on or when the high beam
flasher is operated.
Gives engine speed in rpm.
WARNING
Comes on when fuel level in the tank drops to 4 Ø 1 l.
Refuel as soon as possible when this light comes on.
Comes on when the side stand is down.
Comes on whenever the ignition switch is set to ≈
stopped to test LED operation.
WARNING
on while the engine is running, it means that pressure in the engine
oil circuit is too low.
Comes on when gearbox is in neutral.
Comes on and stays on for about three seconds whenever the ignition
switch is set to "
WARNING
detected some failure event. This may occur while the engine is
EFI
running or as soon as the ignition switch is operated. Normally, the
engine will keep running though performance may be somewhat
impaired. The wording "EFI" only lights up on the multifunction
digital display during service inspections by Aprilia Franchised
Dealers.
Gives road speed.
Function
Never exceed maximum engine rpm.
If the oil pressure LED "
after engine has been started up, or comes
∆ to test LED operation.
The diagnostics LED "EFI" will flash to
indicate that the on-board computer has
ETV mille
2
4
3
1
∆ and the engine is
" stays on
CONTINUED ➤
Release 00/2004 - 04