Reference Guide - APRILIA ETV mille Workshop Manual

Hide thumbs Also See for ETV mille:
Table of Contents

Advertisement

INTRODUCTION

0.2 REFERENCE GUIDE

ETV mille
1.9 PLACING THE MOTORCYCLE ON THE
SERVICE STAND
1.9.1 PLACING THE MOTORCYCLE ON THE FRONT
WHEEL STAND
Place the motorcycle on the centre stand.
Slide both pins (1) of the front wheel stand into the
holes (2) at front fork bottom end of the same time.
Put one foot on the front end of the stand (3).
Press down on stand (3) until it rests fully on the
ground.
1.9.2
PLACING THE MOTORCYCLE ON THE
CENTRE STAND
Read paragraph 0.5.1 (GENERAL PRECAUTIONS
AND INFORMATION) carefully.
Part no. 8140176 (complete stand).
Remove the lower fairing, see 7.1.33 (REMOVING
THE LOWER FAIRING).
Place the motorcycle on the front wheel stand
1.9.1 (PLACING THE MOTORCYCLE ON THE
FRONT WHEEL STAND).
Hold the nut (1) steady on the inside.
Release and remove the rear upper right-hand
engine mounting bolt (2).
Torque wrench setting for nut (1) / bolt (2):50
Nm (5,0 kgm).
NOTE
Collect the nut (1).
Slide the upper right-hand mounting boss (3) into the
upper hole on the right-hand side.
Fit the stud bolt (4) into the upper hole on the left-hand
side and screw it fully into the mounting boss (3).
Screw the upper left-hand mounting boss (5) fully onto
stud bolt (4) and tighten.
Hold the nut (6) on the inside steady.
Release and remove the rear lower engine mounting
bolt (7).
Release 00/2002 - 01
1) Motorcycle model (or engine type)
2) Section title
3) Release progressive number (≈00∆ identifies the original
release)
4) Year and month of issue of relevant release
5) Section number
6) Page number (pages are numbered sequentially,
numbering begins anew in each section)
0
- 6 -
00
The bolt (2) on the left-hand side is longer
GENERAL INFORMATION
2
, see
1
5
4
3
7) Page update number (progressive number)
8) Subsection number (progressive number)
9) Paragraph number (progressive number)
10) Description of operation (always preceded by the
lozenge symbol)
11) Description of operation: the star means that the
operation must be repeated on the opposite side of the
motorcycle
ETV mille
1
2
3
7
6
1
- 17 -
00
Release 00/2004 - 04

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents