APRILIA ETV mille Workshop Manual page 113

ENGINE
!
Release and remove the screw (5). Disconnect the
lead of the neutral switch (6).
!
Remove the expansion reservoir, see 5.6 (REMOVING
THE EXPANSION RESERVOIR).
!
Slip off the dust cap (7) and disconnect the lead of the
engine oil pressure sensor (8) at sensor end.
!
Slip off the dust cap (9), undo and remove the nut (10),
collect the washer and disconnect the starter motor
lead.
WARNING
The brake fluid reservoir (12) must remain in a
vertical position at all times to avoid loss of brake
fluid.
!
Remove the clutch slave cylinder, see 3.2.1 (CLUTCH
SLAVE CYLINDER REMOVAL).
!
Remove the drive sprocket, see 7.8.1 (REMOVING
THE REAR SWINGING ARM).
!
Remove the gear shift lever, see 7.1.40 (REMOVING
THE REAR BRAKE LEVER).
!"
Pull the spark plug caps off the plugs (13).
WARNING
Clean the outer surface of engine with a degreasing
detergent, brushes and rags.
Ensure that no rubber or plastic parts come in
contact with detergents and corrosive or penetrating
solvents.
Should you need a steam cleaner, do not direct water,
steam or high-pressure air jets towards any of the
following parts: wheel hubs, controls on right and
left handlebars, brake master cylinders, instruments
and indicators, silencer outlets, glove compartment,
ignition switch/steering lock, electrical components.
3 - 8 -
00
6
5
12
13
ETV mille
8
7
9
10
Release 00/2004 - 04