Multifunction Computer; Key; Programming Buttons; Instrument Panel Light Intensity - APRILIA ETV mille Workshop Manual

PERIODIC MAINTENANCE AND ADJUSTMENTS

2.3 MULTIFUNCTION COMPUTER

2.3.1 KEY

A Left-hand digital display (odometer, shows total km/
miles covered)
B Right-hand multifunction digital display (fuel level/air
temperature √ coolant temperature √ clock/injection
diagnostics)
C SET and MODE programming buttons.

2.3.2 PROGRAMMING BUTTONS

CAUTION
Perform these operations when the motorcycle is at
standstill.
Performing these operations while riding may lead to
an accident.
NOTE
The instructions given below are referred to the
motorcycle with the engine stopped.
Rotate the ignition switch key (1) to position
following instrument panel lights will come on within the
next three seconds:
- all warning LED lights;
- all backlighting LEDs;
- all segments of the left-hand display;
- all segments and messages of the right-hand
multifunction display.
This is part of an auto-test routine of LED, message,
segment and instrument operation.
After three seconds, all lights except the oil pressure LED
≈ ≈ (2) (which stays on until engine is started up) will
go out and the display will show:
- total distance covered in kilometres (3);
- fuel level (4);
- coolant temperature (5) [characters "---" are displayed
until coolant warms up to 35° C (95° F)];
- time (hours and minutes format) (6).

2.3.3 INSTRUMENT PANEL LIGHT INTENSITY

There are three different settings available for instrument
panel light intensity: 100%; 60%; 25%.
How to set:
&
Set the light switch (1) to "
&
Set the light dip switch "
NOTE
Three seconds after the last selection, the SET
button will revert to odometer/trip meter toggle mode.
2 - 8 -
00
. The
";
" - " " (2) to " ".
5 6
7
4
8
3
2
10
120
140
100 160
1
80
180
0
60
200
40 220
20 240
0
A
2
1
5 6
7
4
8
3
2
120
140
100
160
1
80
180
0
60
200
40
220
20 240
0
6
3
1
ETV mille
B
9
C
4
5
9
10
2
Release 00/2004 - 04