How To Apply The Decals - APRILIA ETV mille Workshop Manual

ETV mille

1.10 HOW TO APPLY THE DECALS

Whenever you remove any body parts:
WARNING
Handle plastic and paint-finished parts with care to
avoid scratching or damage.
Proceed carefully.
Do not damage the snap-on tabs and matching
recesses.
Strictly follow the instructions below.
We recommend using:
- a medium spatula (1);
NOTE
Soft spatulas √ such as those commonly used
on windscreen wipers - will leave excess water under the
decal.
- a sponge or spray dispenser (2) and water.
NOTE
Add water with 1-3% detergent and shake to
obtain frothing.
Apply the decals as follows:
!
Place a decal (3) on a bench with the adhesive face up.
!
Keep the decal well stretched on the bench and
remove the protective film (4).
NOTE
A spray dispenser (2) will work best.
If you are using a sponge, dab the decal surface lightly or
the adhesive will deteriorate.
!
Wet the adhesive face with soap water.
!
Place the decal (3) in the proper position on the part
you wish to decorate.
NOTE
Always apply the spatula to the decal centre and
move it towards the edges with regular movements.
!
Rub the spatula (1) across the decal surface pressing
moderately until removing excess soap and water from
under the decal.
NOTE
Take care not to lift the decal corners and edges
in the process.
!
Dry up the decal with an absorbent cloth. Apply cloth in
the centre and move outwards.
!
Rub the decal using the spatula with firm, regular
strokes. Apply the spatula in the centre and move
outwards. Take special care with corners and edges to
ensure proper adhesion across the whole surface.
Release 00/2004 - 04
GENERAL INFORMATION
4
3
1
1
2
3
1
- 19 -
00