APRILIA ETV mille Workshop Manual page 293

CHASSIS
! Fit the copper washer (14) to the capscrew (13).
! Start the capscrew (13) in its hole and tighten to the
specified torque.
Torque wrench setting for capscrew (13): 50 Nm
(5.0 kgm).
! Insert the spring (15) into the slider (1).
!#Pour front fork fluid into the slider (1) up to correct
level. See 1.6 (LUBRICANT CHART) for specifications.
Measure level fitting a graduated rod (16) into the slider
(1).
Oil quantity: 750 ± 2.5 cu. cm.
Oil level: 120 ± 2 mm (from slider edge).
NOTE
The slider (1) must be perfectly vertical to
ensure accurate measurement. Oil level must be the
same in both fork legs.
!# Insert the spacer tube (17) into the slider (1).
!# Make sure the O-ring (19) is fitted to the slider top cap
(18).
!# Start the slider top cap (18) in the slider (1) and
tighten to the specified torque.
Torque wrench setting for slider top cap (18): 20
Nm (2.0 kgm).
7 - 82 -
00
13
14
17
1
18
1
ETV mille
15
16
19
Release 00/2004 - 04