Side Stand Removal - APRILIA ETV mille Workshop Manual

CHASSIS

7.1.43 SIDE STAND REMOVAL

Read 0.5.1 (GENERAL
INFORMATION) carefully.
!
Place the motorcycle on the centre stand
WARNING
Take care not to damage the switch (1).
The nut (2) should never be disturbed while the
switch (1) is in place.
!#
Remove the fuel tank, see 7.1.4 (REMOVING THE
FUEL TANK).
!#
Disconnect the connector (3) from the main wiring
harness.
WARNING
Ensure that the connector (3) is fitted to the matching
connector on assembly.
!#
Release the wire from the hook.
WARNING
Make sure to route the wire correctly when refitting.
!
Release the two springs (4).
!
Undo and remove the nut (2) and collect the washers
(5).
Torque wrench setting for nut (2): 30 Nm (3.0
kgm).
!
Release and remove the pivot bolt (7) complete with
stand switch (1).
!
Remove the stand (6).
If you need to remove the side stand switch (1) only:
!
Perform the steps identified with an "#".
!
Release and remove the screw (8) and collect the
washer (9).
WARNING
Apply LOCTITE ® 243 to the thread of screw (8) on
assembly.
!
Remove the switch (1).
7 - 42 -
00
PRECAUTIONS AND
.
3
1
8 9 7
5
2
4
ETV mille
4
2 6
6
Release 00/2004 - 04