Specifies the position to print the terminal ID information in the sent fax. Select <Inside Image Area> to print the
information inside the image area, or <Outside Image Area> to print the information outside the image area.
<Mark Number as>
Adds the "FAX" or "TEL" mark in front of the fax number registered for the machine (
and Unit Name). Select <TEL> to indicate that the notified number is a telephone number.
Check Dial Tone Before Sending
Select whether to check the dial tone before a fax number is dialed.
RX Function Settings
Specify settings for receiving faxes.
Enable or disable error correction mode (ECM). ECM checks for fax data errors and corrects them. To reduce errors on sent faxes,
ECM must be enabled on both the machine and the other fax device because error check is performed on both the sending
and receiving devices.
Even when ECM is enabled, errors may occur due to telephone line conditions.
It may take a longer time than usual to process data when ECM is enabled because the error check and corrections are
performed while the data is transmitted.
Downloaded from ManualsPrinter.com Manuals
<TX Function Settings>
<RX Function Settings>
Registering the Fax Number
<Check Dial Tone Before Sending>