If you select JPEG in <File Format>, only one page can be scanned when the document is placed on the platen glass. To scan
multiple documents at a time, place them in the feeder. These documents will be scanned and saved as separate files. For PDF or
TIFF files, multiple documents can be scanned and saved into one set of files, regardless of whether documents are placed on
the platen glass or in the feeder.
If you want to cancel scanning, press <Cancel>
When placing documents in the feeder in step 2
When scanning is complete, the scanned data is saved in the USB memory device.
When placing documents on the platen glass in step 2
When scanning is complete, follow the procedures below (except if you selected JPEG as a file format in step 5).
If there are additional pages of documents to be scanned, place the next document on the platen glass,
Repeat this step until you finish scanning all of the pages.
When there is only one page to be scanned, proceed to the next step.
Press <Store & Finish>.
The scanned data is saved in the USB memory device.
How the folders to save scanned data and files are named
When scanning is complete, a folder is automatically created in the USB memory device to save the scanned data. Folders and
files are named as follows.
The "SCAN_00" folder is created and up to 100 files are saved in the folder. The folders "SCAN_01" to "SCAN_99" are
then created when the current folder becomes full of 100 files.
File names from "SCAN0000.XXX" to "SCAN9999.XXX" are given to the scanned data files ("XXX" is the extension for
the file format such as "JPG"). For the first two numerical digits, the same number is allotted as that of the folder
number in which the files are saved. For example, The fifth JPEG file stored in the "SCAN_01" folder is named
Disconnect the USB memory device from the USB memory port.
Select <Remove Memory Media>, and press
Wait until the message <The memory media can be safely removed.> is displayed.
Disconnect the USB memory device.
If you always want to scan with the same settings:
Downloaded from ManualsPrinter.com Manuals
to select <Device Status>, and press
Changing Default Settings