IP addresses assigned via DHCP/BOOTP/RARP override the address obtained via Auto IP.
Manually entering an IP address
Check that <Auto Acquire> is set to <Off>.
If <On> is displayed, select <Auto Acquire>
Select <Manually Acquire>, and press
Specify the IP address, subnet mask, and gateway address (or default gateway).
Specify the settings in the following order: <IP Address>
Enter the setting using the numeric keys, and press <Apply> on each screen.
Restart the machine.
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Checking whether the settings are correct
Make sure that the Remote UI screen can be displayed with your computer. (
available, you can check the connection by using the operation panel (
Testing the Network Connection
to select <Network Settings>, and press
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press
Enter the IPv4 address of another device on the network, and press <Apply>.
If a proper connection has been established, the result is displayed as shown above.
Downloaded from ManualsPrinter.com Manuals
, and set both <Select Protocol> and <Auto IP> to <Off>.
Starting Remote UI) If a computer is not
Testing the Network Connection).
Logging on to the