Setting IPv6 Addresses
Start the Remote UI and log on in System Manager Mode.
Click [Network Settings]
Click [Edit...] in [IPv6 Settings].
Downloaded from ManualsPrinter.com Manuals
The IPv6 addresses of the machine can be configured via the Remote UI. Before setting IPv6 addresses,
check the IPv4 address settings (
IPv6 addresses. Note that the scan function that uses the scanner driver or MF Toolbox is not available in an
IPv6 environment. The machine can use up to nine of the following IPv6 addresses:
An address that is only valid within a subnet or link and cannot be used to communicate with
devices beyond a router. A link-local address is automatically set when the IPv6 function of the
machine is enabled.
An address that is entered manually. When using this address, specify the prefix length and
default router address.
An address that is generated automatically using the MAC address of the machine and the
network prefix that is advertised by the router. Stateless addresses are discarded when the
machine is restarted (or turned ON).
An address obtained from a DHCP server using DHCPv6.
Viewing IPv4 Settings). You need to set the correct IPv4 settings to use
Starting Remote UI