To check the settings registered in the key, see
To cancel, press <Cancel>
You cannot scan while the MF Toolbox setup screen is displayed. Close the screen
When placing documents in the feeder in step 1
When scanning is complete, the save destination folder is displayed on the computer.
When placing documents on the platen glass in step 1
When scanning is complete, follow the procedure below.
If there are additional pages of documents to be scanned, place the next document on the platen glass,
select <Scan Next Original>, and press
Repeat this step until you finish scanning all of the pages.
When there is only one page to be scanned, proceed to the next step.
Press <Store & Finish>.
The save destination folder is displayed on the computer.
About the save destination folder
By default, the scanned data is saved to the [Pictures] or [My Pictures] folder. A subfolder named with the scanning date is
created, and the data is saved to that folder.
To change the save destination, see
Scanning from the Machine
Downloaded from ManualsPrinter.com Manuals
Checking the Registered Settings.
Configuring Storing Settings.