Configuring Ts - 3Com 4200G 12-Port Configuration Manual

230 C 27: Q S C
HAPTER O
Configuration Example

Configuring TS

Configuration
Prerequisites
Configuration Procedure
ONFIGURATION
Table 197 Clearing the statistics of TP
Display the statistics of TP
The GigabitEthernet1/0/1 of the switch is accessed into the 10.1.1.1/24 network
■
segment
Perform TP on the packets from the 10.1.1.1/24 network segment and the rate of
■
TP is set to100kbps
The packets within the specified traffic are forwarded after their DSCP precedence
■
is marked as 16, and the packets beyond the traffic are forwarded after their DSCP
precedence is marked as 56
Configuration procedure
<S4200G> system-view
System View: return to User View with Ctrl+Z.
[4200G] acl number 2000
[4200G-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[4200G-acl-basic-2000] rule deny source any
[4200G-acl-basic-2000] quit
[4200G] interface gigabitEthernet1/0/1
[4200G-GigabitEthernet1/0/1] traffic-limit inbound ip-group 2000 100
Refer to T for the introduction to TS.
Whether the TS is performed on all the traffic on the port or the specified output
■
queues on the port is determined
The max rate and burst size of the port in the TS are specified
■
The ports that needs this configuration is specified
■
Table 198 Configuring TS
Operation
Enter system view
Enter Ethernet port view
display qos-interface
{ interface-type
interface-num | unit-id }
traffic-limit
Command
system-view
interface interface-type
interface-number
Required
The statistics of TP includes the bytes of
the packets within the limited rate and
the bytes of the packets beyond the
limited rate.
When the statistics count reaches the
upper threshold, the switch will restart
statistics. It is recommended to use the
display command to display within 30
seconds after the reset command is
executed
Description
-
TS cannot be performed on the piled
ports