Telnet Configuration With Authentication Mode Being Password - 3Com 4200G 12-Port Configuration Manual

102 C 19: L
HAPTER OGGING IN THROUGH
Telnet Configuration
with Authentication
Mode Being Password
Configuration Procedure
T
ELNET
Network diagram
Figure 30 Network diagram for Telnet configuration (with the authentication mode being
none)
Configuration procedure
1 Enter system view.
<S4200G> system-view
2 Enter VTY 0 user interface view.
[4200G] user-interface vty 0
3 Configure not to authenticate Telnet users logging into VTY 0.
[4200G-ui-vty0] authentication-mode none
4 Specify commands of level 2 are available to users logging into VTY 0.
[4200G-ui-vty0] user privilege level 2
5 Configure Telnet protocol is supported.
[4200G-ui-vty0] protocol inbound telnet
6 Set the maximum number of lines the screen can contain to 30.
[4200G-ui-vty0] screen-length 30
7 Set the maximum number of commands the history command buffer can store to 20.
[4200G-ui-vty0] history-command max-size 20
8 Set the timeout time to 6 minutes.
[4200G-ui-vty0] idle-timeout 6
Table 79 Telnet configuration with the authentication mode being password
Operation
Enter system view
Enter one or more VTY
user interface views
RS-232 RS-232
Console cable Console cable
Command
system-view
user-interface vty first-number [
last-number ]
Console port Console port
Description
—
—