3Com 4200G 12-Port Configuration Manual page 354

340 C 38: FTP
HAPTER AND
TFTP Configuration
TFTP Configuration
Example
TFTP C
ONFIGURATION
Table 293 describes the operations needed when a switch operates as an TFTP client.
Table 293 Configurations needed when a switch operates as a TFTP client
Device Configuration
Switch Configure an IP address for the
VLAN interface of the switch so
that it is reachable for TFTP
server.
You can log into a TFTP server
directly for file accessing
through TFTP commands.
PC The TFTP server is started and
the TFTP work directory is
configured.
Prerequisites
A switch operates as a TFTP client. A PC operates as the TFTP server. The network
operates properly, as shown in Figure 108 4.
Configuration procedure
Table 294 Configure TFTP
Operation
Set the TFTP file
transmission mode
Download a file
Upload a file
Enter system view
Specify the ACL
adopted when a switch
attempts to connect a
TFTP server
Network requirements
A switch and a PC operate as a TFTP client and the TFTP server.
The TFTP work directory is configured on the TFTP server.
■
The IP address of a VLAN interface on the switch is 1.1.1.1. The port through
■
which the switch connects with the PC belongs to the VLAN. The IP address of the
PC is 1.1.1.2.
Download the application named switch.bin from the PC to the switch and upload
the configuration file named vrpcfg.txt to the directory named Switch on the PC to
backup the configuration file.
Default
—
—
—
Command
tftp { ascii | binary }
tftp tftp-server get source-file [
dest-file ]
tftp tftp-server put source-file [
dest-file ]
system-view
tftp-server acl acl-number
Description
TFTP applies to networks where
client-server interactions are
comparatively simple. It requires the
routes between TFTP clients TFTP
servers are reachable.
—
—
Description
Optional
By default, the binary file
transmission mode is adopted.
Optional
Optional
—
Optional