Console Port Login Configuration - 3Com 4200G 12-Port Configuration Manual

Console Port Login
Configuration
Common Configuration
Figure 4 Set port parameters
Turn on the switch. The user will be prompted to press the Enter key if the switch
■
successfully completes POST (power-on self test). The prompt (such as <S4200G>)
appears after the user presses the Enter key.
You can then configure the switch or check the information about the switch by
■
executing commands. You can also acquire help by type the ? character.
Table 12 lists the common configuration of Console port login.
Table 12 Common configuration of Console port login
Configuration
Console port Baud rate
configuration
Check mode
Stop bits
Data bits
AUX user Configure the command
interface level available to the
configuration users logging into the
AUX user interface

Console Port Login Configuration

Description
Optional
The default baud rate is 9,600 bps.
Optional
By default, the check mode of the Console port is set
to "none", which means no check bit.
Optional
The default stop bits of a Console port is 1.
Optional
The default data bits of a Console port is 8.
Optional
By default, commands of level 3 are available to the
users logging into the AUX user interface.
13