3Com 4200G 12-Port Configuration Manual page 398

384 C 45: C
HAPTER ONFIGURATION OF
Configuring Cluster
Management
N A C F
EWLY DDED LUSTER UNCTIONS
#
radius scheme system
#
domain system
#
vlan 1
#
snmp-agent
snmp-agent local-engineid 800007DB000FE224055F6877
snmp-agent community read aaa@cm2
snmp-agent community write bbb@cm2
snmp-agent sys-info version all
snmp-agent group v3 ggg
snmp-agent target-host trap address udp-domain 168.192.0.1 params
securityname
cluster
snmp-agent mib-view included mmm org
snmp-agent usm-user v3 uuu ggg
snmp-agent usm-user v3 user1 g1
snmp-agent trap source Vlan-interface1
#
Configuring member management
■
In member management, you can:
Specify a candidate device that will join the cluster and delete the specific
■
member device in the cluster manually. You are allowed to add or delete a
cluster member only on the management device; otherwise the system gives an
error prompt.
Control the member device remotely through the remote control function of
■
the management device if a member device fails due to incorrect
configuration. For example, you can delete the boot file and restart the
member device to bring the management device and the member device back
to normal communication.
Manage blacklists.
■
Locate a device through the MAC address or the IP address.
■
Configure the specified member device on the management device after
■
switching to the member device view. After the configuration, you can switch
back to the management device.
Configure member management
Table 331
Operation Command
Enter system view
system-view
Enter cluster view
cluster
Add a candidate device
add-member [ member-number
to the cluster
] mac-address mac-address
[ password password ]
Delete a member
delete-member
device from the cluster
member-number [
to-black-list ]
Description
-
-
Optional
Member numbers are assigned
based on a certain order. The
number that the member with the
same MAC address used is
recorded by the management
device
Optional