Remote Software Loading - 3Com 4200G 12-Port Configuration Manual

Remote Software
Loading
Remote Loading Using
4 Enter 2 in the above menu to download the BootROM software using FTP. Then set
the following FTP-related parameters as required:
Load File name
Switch IP address
Server IP address
FTP User Name
FTP User Password
5 Press <Enter>. The system displays the following information:
Are you sure to update your bootrom?Yes or No(Y/N)
6 Enter Y to start file downloading or N to return to the Bootrom update menu. If you
enter Y, the system begins to download and update the program. Upon completion,
the system displays the following information:
Loading........................................done
Bootrom updating..........done!
Loading host software
Follow these steps to load the host software:
1 Select <1> in Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
2 Enter 2 in the above menu to download the host software using FTP.
The subsequent steps are the same as those for loading the BootROM program,
except for that the system gives the prompt for host software loading instead of
BootROM loading.
If your terminal is not directly connected to the switch, you can telnet to the switch,
and use FTP or TFTP to load BootROM and host software remotely.
As shown in Figure 118, a PC is used as both the configuration device and the FTP
FTP server. You can telnet to the switch, and then execute the FTP commands to
download the host program S4200G.bin and the BootROM program S4200G.btm
from the remote FTP server (with an IP address 10.1.1.1) to the switch.
:S4200G.btm
:10.1.1.2
:10.1.1.1
:4200G
:abc

Remote Software Loading 361