3Com 4200G 12-Port Configuration Manual page 44

30 C 5: L
HAPTER OGGING IN THROUGH
W - N
EB BASED ETWORK
Launch a terminal emulation utility (such as Terminal in Windows 3.X or
■
HyperTerminal in Windows 9X) on the PC, with the baud rate set to 9,600 bps,
data bits set to 8, parity check set to off, and flow control set to off.
Turn on the switch. When the switch is starting, the information about self-testing
■
appears on the terminal window. When you press Enter after the self-testing
finishes, the prompt (such as <S4200G>) appears, as shown in the Figure 12.
Figure 12 The terminal window
Execute the following commands in the terminal window to assign an IP address
■
to the management VLAN interface of the switch.
<S4200G> system
a Enter management VLAN interface view.
[4200G] interface vlan-interface 1
b Remove the existing IP address of the management VLAN interface.
[4200G-VLAN-interface1] undo ip address
c Configure the IP address of the management VLAN interface to be 10.153.17.82.
[4200G-VLAN-interface1] ip address 10.153.17.82 255.255.255.0
2 Configure the user name and the password for the Web-based network management
system.
Add a Telnet user account for the switch, setting the user level to level 3 (the
■
administration level).
a Configure the user name to be admin.
[4200G] local-user admin
b Set the user level to level 3.
[4200G-luser-admin] service-type telnet level 3
c Set the password to admin.
[4200G-luser-admin] password simple admin
Configure a static route from the switch to the gateway.
■
[4200G] ip route-static ip-address 0.0.0.0 255.255.255.255
M S
ANAGEMENT YSTEM