3Com 4200G 12-Port Configuration Manual page 97
4200g series switch
Hide thumbs
Also See for 4200G 12-Port:
- Configuration manual (730 pages) ,
- Getting started manual (104 pages) ,
- Quick reference manual (43 pages)
Table of Contents
Advertisement
2 Adopting static LACP aggregation mode
a Create static aggregation group 1.
<S4200G> system-view
[4200G] link-aggregation group 1 mode static
b Add ports GigabitEthernet1/0/1 through GigabitEthernet1/0/3 to aggregation
group 1.
[4200G] interface GigabitEthernet1/0/1
[4200G-GigabitEthernet1/0/1] port link-aggregation group 1
[4200G-GigabitEthernet1/0/1] interface GigabitEthernet1/0/2
[4200G-GigabitEthernet1/0/2] port link-aggregation group 1
[4200G-GigabitEthernet1/0/2] interface GigabitEthernet1/0/3
[4200G-GigabitEthernet1/0/3] port link-aggregation group 1
3 Adopting dynamic LACP aggregation mode
a Enable LACP on ports GigabitEthernet1/0/1 through GigabitEthernet1/0/3.
<S4200G> system-view
[4200G] interface GigabitEthernet1/0/1
[4200G-GigabitEthernet1/0/1] lacp enable
[4200G-GigabitEthernet1/0/1] interface GigabitEthernet1/0/2
[4200G-GigabitEthernet1/0/2] lacp enable
[4200G-GigabitEthernet1/0/2] interface GigabitEthernet1/0/3
[4200G-GigabitEthernet1/0/3] lacp enable
Note that, the three LACP-enabled ports can be aggregated into a dynamic
aggregation group to implement load sharing only when they have the same basic
configuration (such as rate and duplex mode).
Link Aggregation Configuration Example
83
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
