B.2.3.1 Network Parameters - Image Access WideTEK A2 Operation Manual

B.2.3.1 Network Parameters
A network configuration screen will appear.
IP Configuration Method: Manual
Host Name:
IP Address:
Subnet Mask:
Default Gateway: Enter the value for the gateway here. If no gateway is used, enter the
Broadcast:
All of the above mentioned settings must correspond to the network in which the scanner
is used.
Click on the button Apply to store the changed settings.
NOTE: After saving the changed IP address the connection to the scanner is lost. To
reconnect to the scanner, enter the new IP address in your browser.
Operation Manual
Picture 19: Configure network parameters
Automatically set. Can not be changed.
Enter the IP address. The IP address must identify the scanner
clearly in the network in which it is installed.
Enter a valid value for your network here. In most cases this is:
255.255.255.0
Ask your network administrator in case of deviations.
scanner IP address.
Enter the highest possible value here. Ask your network administrator
for the correct value.
Page 27