Switching To Stand-By Mode; Starting The Widetek A2 - Image Access WideTEK A2 Operation Manual

A.8

Switching to Stand-by Mode

The main power switch is used to switch the WideTEK A2 scanner to stand-by mode. It
also switches the WideTEK A2 scanner completely off. This is only necessary before
transporting or when the scanner is not used for a longer time period.
Press the main power switch to position "I" to set the WideTEK A2 into stand-by mode.
A.9

Starting the WideTEK A2

Press the green stand-by button to switch the WideTEK A2 from stand-by mode to
operating mode. The start sequence takes approximately one minute.
After pressing the green stand-by button, the lamp lights up.
The start sequence takes approximately one minute. During this time, some internal
routines check all device components.
Picture 8: Mechanic Check
Picture 9: Hardware Check
Finally the display shows READY TO SCAN.
Operation Manual
Picture 7: Main power switch
In further progress of the system tests the display
shows some status information
and the current IP address and
Page 19