Tacacs+ Commands - Lantronix SLC 8000 User Manual

User Menus
Web Access
Diagnostics &
Reports
Firmware &
Configuration
Internal Modem
Device Port
Operations
Device Port
Configuration
USB
SD Card
5. Click the Apply button.
Note: You must reboot the unit before your changes will take effect.

TACACS+ Commands

These commands for the command line interface correspond to the web page entries described
above.
To configure the SLC unit to use TACACS+ to authenticate users who log in via the Web,
SSH, Telnet, or the console port:
set tacacs+ <one or more parameters>
Parameters
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
encrypt <enable|disable>
escapeseq <1-10 Chars>
listenports <Port List>
secret <TACACS+ Secret>
server1 <IP Address or Name>
server2 <IP Address or Name>
server3 <IP Address or Name>
state <enable|disable>
To set user group and permissions for TACACS+ users:
set tacacs+ group <default|power|admin>
To set permissions for TACACS+ users not already defined by the user rights group:
set tacacs+ permissions <Permission List>
where
<Permission List> is one or more of nt, sv, dt, lu, ra, sk, um, dp, do,
ub, rs, rc, dr, wb, sn, ad, md, sd
SLC™ 8000 Advanced Console Manager User Guide
Right to create a custom user menu for the CLI for LDAP users.
Right to access Web-Manager.
Right to obtain diagnostic information and reports about the unit.
Right to upgrade the firmware on the unit and save or restore a configuration (all
settings). Selecting this option automatically selects Reboot & Shutdown.
Right to update internal modem settings.
Right to control device ports.
Right to enter device port settings.
Right to enter modem settings for USB devices and control USB storage devices.
Right to enter settings for SD card.
11: User Authentication
208